Inspection of parts with complex geometry and welds with structural health monitoring techniques

Structural Health Monitoring (SHM) systems were developed to evaluate the integrity of a system during operation, and to quickly identify the maintenance problems. They will be used in future aerospace vehicles to improve safety, reduce cost and minimize the maintenance time of a system. Many SHM systems were already developed to evaluate the integrity of plates and used in marine structures. Their implementation in manufacturing processes is still expected. The application of SHM methods for complex geometries and welds are two important challenges in this area of research. This research work started by studying the characteristics of piezoelectric actuators, and a small energy harvester was designed. The output voltages at different frequencies of vibration were acquired to determine the nonlinear characteristics of the piezoelectric stripe actuators. The frequency response was evaluated experimentally. AA battery size energy harvesting devices were developed by using these actuators. When the round and square cross section devices were excited at 50 Hz frequency, they generated 16 V and 25 V respectively. The Surface Response to Excitation (SuRE) and Lamb wave methods were used to estimate the condition of parts with complex geometries. Cutting tools and welded plates were considered. Both approaches used piezoelectric elements that were attached to the surfaces of considered parts. The variation of the magnitude of the frequency response was evaluated when the SuRE method was used. The sum of the square of the differences was calculated. The envelope of the received signal was used for the analysis of wave propagation. Bi-orthogonal wavelet (Binlet) analysis was also used for the evaluation of the data obtained during Lamb wave technique. Both the Lamb wave and SuRE approaches along with the three methods for data analysis worked effectively to detect increasing tool wear. Similarly, they detected defects on the plate, on the weld, and on a separate plate without any sensor as long as it was welded to the test plate.

Relation of health related hardiness to health perception and psychosocial adaptation in adult hispanics with chronic hepatitis C

The purpose of this study was to investigate the role of hardiness in health perception and psychosocial adaptation in adult hispanics with chronic hepatitis C (n = 32). The Health Related Hardiness Scale and the Psychosocial Adaptation to Illness Scale were administered to 32 adult hispanics diagnosed with chronic heptitis C at a gastroenterology center. The results indicate that a comparison of subjects with low and high hardiness scores did not reveal significant differences on any of the PAIS domains (health care orientation, sexual relationships, psychological distress, vocational, domestic and social environments). Furthermore, hardiness subscales of control and committment did not have any influence on patient's psychosocial adaptation nor in its domains. However, a comparison of subjects with low and high challenge scores indicates that those with low challenge had lower total psychosocial adaptation scores (M = 5.55, SD = 2.13) than subjects with high challenge scores (M = 4.24, SD = .67) ,t = (1, 30) = 2.34, p < 0.05. Differences were also found for the domains of health care orientation, psychological distress, social and vocational environment. Lastly, there were significant differences on perceived health rating (poor, fair, and good) for the total hardiness score (F = (2,29) =5.49, p < 0.05), control (F =(2,29) = 4.09, p < 0.05), committment (F=(2,29) = 3.76, p < 0.05) and challenge (F=(2,29)= 4.92, p < 0.05). Thus, those patients who rated their health as poor had lower hardiness levels. Findings have implications for promoting hardiness for better health perception and in certain aspects of psychosocial adaptations in adult hispanics with chronic hepatitis C.